PolySwitch(R) PTC Devices PRODUCT: AHRF600S Overcurrent Protection Device 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 www.circuitprotection.com Raychem Circuit Protection Products DOCUMENT: SCD 26490 PCN: RF0490 REV LETTER: B REV DATE: MAY 8, 2007 PAGE NO.: 1 OF 2 Specification Status: Released Electrical Rating Voltage: 16VDC MAX Insulating Material: Cured, Flame Retardant Epoxy Polymer Lead Material: 20 AWG Tin Plated Copper (0.8 mm [0.032] nom. diameter) Part Marking: TABLE I. INSTALLATION ENVELOPE DIMENSIONS: mm: in*: A B MIN MAX MIN MAX -11.2 -20.4 -(0.44) -(0.80) *Rounded off approximation C MIN 4.3 (0.17) D MAX 5.8 (0.23) MIN 7.6 (0.30) E MAX --- MIN --- MAX 3.0 (0.12) F TYP 1.2 (0.05) G MIN --- MAX 4.19 (0.165) TABLE II. PERFORMANCE RATINGS: CURRENT RATINGS TIME TO TRIP AMPS SECONDS AT AT 25C 25C, 30 A HOLD TRIP MAX 6.0 12.0 6.5 Reference Documents: Precedence: Effectivity: Warning: RESISTANCE Ra MAX OHMS AT 25C MIN MAX .010 .022 OHMS AT 25C 0.032 TRIPPEDSTATE POWER DISSIPATION WATTS AT 25C TYP 4.1 PS400, PS300 This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid. Refer to Page 2 of this document for application limitations. Materials Information ROHS Compliant ELV Compliant (c) 2005, 2007 Tyco Electronics Corporation. All rights reserved Pb-Free PolySwitch(R) PTC Devices 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 www.circuitprotection.com Overcurrent Protection Device Raychem Circuit Protection Products PRODUCT: AHRF600S DOCUMENT: SCD 26490 PCN: RF0490 REV LETTER: B REV DATE: MAY 8, 2007 PAGE NO.: 2 OF 2 TABLE III. AUTOMOTIVE SPECIFIC STRESS TESTS AND TEST CONDITIONS: ELECTRICAL STRESS TESTS TEST CONDITIONS (see note 2) ESD Voltage Withstand (see note 1) Short Circuit Fault Current Durability 25kV Fault Current Durability 350 cycles, 16V/100A End-of-life Mode Verification 1750 cycles, 16V/100A Jump Start Endurance (see note 1) Load Dump Endurance (see note 1) 3 cycles, 26V, 1 minute duration 25 cycles, 16V, 200A 10 cycles, 86.5V Note 1: The PolySwitch devices are tested in series with a load resistance and the voltages specified in the test conditions are shared between the PolySwitch device and the load resistance as specified in PS400. Note 2: Please refer to Appendix A of PS400 for the detailed test procedures